DAE Plumbing installs new gas, electric, tankless, and high-efficiency water heaters in Hollister and the surrounding five-county area. We size each unit to real household demand, run the gas, venting, and water connections it needs, and install to current California code with seismic strapping and relief piping. Permits are coordinated and estimates are free.
When You Need Water Heater Installation
Installation is different from a like-for-like swap. It means putting in a water heater where the existing plumbing was not built for the one you want.
- You need installation work when a new home or addition needs its first water heater. It is also the right service when converting from a tank to tankless, which needs new venting and a larger gas line, or when moving the heater out of a closet, attic, or living space.
- It also covers adding a second unit for a large home or an accessory dwelling unit, and pairing a heater with a boiler or recirculation loop. Growing households call us when the existing heater simply cannot keep up.
- If the old unit still works but no longer fits how you live, installation is the conversation to have.
If it has failed or is leaking, water heater replacement is the faster path.
Building, adding on, or moving your water heater? Tell us about the space and your household and we will size the right unit.
๐ Call (831) 801-1079Mon-Fri 7am-5pm, weekends by appointment
What the Installation Process Looks Like
Every installation starts with sizing. We count bathrooms, fixtures, and people, check the fuel supply, and calculate peak demand before recommending a unit.
- Tankless units are sized by flow rate and temperature rise, and tanks by first-hour rating. Next we plan the location: clearances, combustion air, venting route, condensate drainage, and access for future service.
- On installation day we set the unit, run or upsize the gas line, install the venting, and plumb the hot and cold connections with isolation valves. California code items go in at the same time: seismic strapping, a relief valve with a discharge line, a drain pan where required, and an expansion tank when needed.
We then fill, purge, fire, and test the system, set the temperature, and show you how to maintain it.



